Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 04 (MONITORING SYSTEM AND FAULT CODES) 200 smr2009-029 FAULT CODE MODULE DESCRIPTION POSSIBLE CAUSE SERVICE ACTION P0217 ECM High engine coolant temperature detected Engine overheated or damaged sensor Check for debris or blockage in cooling system. Check the sensor for approximately 2280 to 2736 ohms at 19 to 21°C (66 to 70°F). Check for approximately 2280 to 2736 ohms at 19 to 21°C (66 to 70°F) between ECM connector pins A-A1 and A-J2. Refer to the Service Manual for more details.

P0222 ECM TAS (Throttle Accelerator sensor) 2 fault (short circuit to GND) Damaged sensor, damaged circuit wires, damaged connector or damaged ECM pins Check system circuits B-A3, B-B3, B-J3. Check for 0 volt on sensor connector pin B. Check for 5 volts on sensor connector pin A. Check for 0.25 to 1.5 volts on sensor connector pin C. Refer to the Service Manual for more details. P0223 ECM TAS (Throttle Accelerator sensor) 2 fault (short circuit to battery) Damaged sensor, damaged circuit wires, damaged connector or damaged ECM pins Check system circuits B-A3, B-B3, B-J3. Check for 0 volt on sensor connector pin B. Check for 5 volts on sensor connector pin A.

Check for 0.25 to 1.5 volts on sensor connector pin C. Refer to the Service Manual for more details. P0231 ECM Fuel pump open circuit or short to ground Damaged pump, damaged circuit wires, damaged connector or damaged ECM output pins. Check for approximately 1 ohm between pins A and B of the fuel pump connector. Check fuse 6 (refer to WIRING DIAGRAM). Check for damaged circuit wires. Check for damaged connector, damaged ECM output pins or ECM failure. Refer to the Service Manual for more details.

P0232 ECM Fuel pump short circuit to battery Damaged pump, damaged circuit wires, damaged connector or damaged ECM output pins Check for approximately 1 ohm between pins A and B of the fuel pump connector. Check fuse 6 (refer to WIRING DIAGRAM). Check for damaged circuit wires. Check for damaged connector, damaged ECM output pins or ECM failure. Refer to the Service Manual for more details.