Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 04 (MONITORING SYSTEM AND FAULT CODES) 210 smr2009-029 FAULT CODE MODULE DESCRIPTION POSSIBLE CAUSE SERVICE ACTION P2428 ECM High exhaust temperature detected Exhaust overheat, damaged sensor or damaged circuit wires. Check cooling system for blockage. Check if the exhaust injection valve is properly calibrated. Refer to the Service Manual for more details. P2620 ECM TPS value not plausible Damaged throttle actuator, damaged circuit wires, damaged connector or damaged ECM Check system circuit, perform closed throttle with B.U.D.S. Replace throttle actuator, replace ECM.

P2621 ECM Electrical lower-range violation TPS 1 Damaged throttle actuator, damaged circuit wires, damaged connector or damaged ECM Check system circuit, perform closed throttle with B.U.D.S. Replace throttle actuator, replace ECM. P2622 ECM Electrical upper-range violation TPS 1 Damaged throttle actuator, damaged circuit wires, damaged connector or damaged ECM Check system circuit, perform closed throttle with B.U.D.S. Replace throttle actuator, replace ECM. P3999 ECM Dummy U0129 ECM CAN communication error between ECM and iBR module iBR fault detected by ECM CAN circuit failure, iBR or ECM failure Check CAN circuits wires. Replace iBR. Refer to the Service Manual for more details.

U0129 iS iBR CAN messages time out or validity Warning only: the iS module lost communication with the iBR If fault ACTIVE, verify CAN connection between iBR and iS. U016A ECM Loss of vehicle speed Instrument cluster fault detected by ECM CAN circuit failure, instrument Cluster or ECM failure Check CAN circuits wires, replace instrument Cluster. Refer to the Service Manual for more details. U0300 ECM Exchange security - Wrong ECM Incorrect ECM or cluster for engine Install proper recommended ECM or cluster for vehicle. U0401 iBR ECM CAN messages time out or validity CAN circuit failure, ECM software failure Check CAN circuits wires. Replace ECM. Refer to the Service Manual for more details.

U0401 iS ECM CAN messages time out or validity Warning only: the iS module lost communication with the engine ECU If fault ACTIVE, verify CAN connection between ECM and iS. U0457 iBR Cluster CAN messages timeout or validity CAN circuit failure, Cluster software failure Check CAN circuits wires. Replace instrument Cluster. Refer to the Service Manual for more details. U0457 iS Cluster CAN messages time out or validity Warning only: the iS module lost communication with the Cluster If fault ACTIVE, verify CAN connection between Cluster and iS.