Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 04 (MONITORING SYSTEM AND FAULT CODES) smr2009-029 209 FAULT CODE MODULE DESCRIPTION POSSIBLE CAUSE SERVICE ACTION P16C5 ECM Safety fuel cut off activ - Monitoring level 1 P16C6 ECM Safety fuel cut off activ - Monitoring level 2 P16C7 ECM Monitoring fault due to throttle valve plausibility check Damaged throttle actuator, damaged circuit wires, damaged connector or damaged ECM Check system circuit, perform closed throttle with B.U.D.S. Replace throttle actuator, replace ECM.

P16C8 ECM Monitoring fault due to exceeding permitted throttle valve position Damaged throttle actuator, damaged circuit wires, damaged connector or damaged ECM Check system circuit, perform closed throttle with B.U.D.S. Replace throttle actuator, replace ECM. P16C9 ECM Monitoring detected non plausible D.E.S.S. key state Damaged D.E.S.S. key switch, damaged circuit wires, damaged connector or damaged ECM output pins Remove D.E.S.S. key and check system circuit B-B2. Refer to the Service Manual for more details.

P2080 ECM Exhaust temperature not plausible Damaged sensor, damaged circuit wires, damaged connector or damaged ECM output pins Check for approximately 2280 to 2736 ohms at temperature of 19 to 21°C (66 to 70°F) between system circuits A-H4 and A-J4. Refer to the Service Manual for more details. P2081 ECM Exhaust temperature sensor fault Intremittent connection. Damaged sensor, damaged circuit wires, damaged connector or damaged ECM output pins Check for approximately 2280 to 2736 ohms at temperature of 19 to 21°C (66 to 70°F) between system circuits A-H4 and A-J4. Refer to the Service Manual for more details.

P212C ECM Electrical lower-range violation TPS 2 Damaged throttle actuator, damaged circuit wires, damaged connector or damaged ECM Check system circuit, perform closed throttle with B.U.D.S. Replace throttle actuator, replace ECM. P212D ECM Electrical upper-range violation TPS 2 Damaged throttle actuator, damaged circuit wires, damaged connector or damaged ECM Check system circuit, perform closed throttle with B.U.D.S. Replace throttle actuator, replace ECM. P2159 ECM TAS (Throttle Accelerator sensor) signal not plausible Damaged sensor, damaged circuit wires, damaged connector or damaged ECM pins Check system circuits B-E1, B-K1, B-K3, B-A3, B-B3, B-J3.

Check for 0 volt on sensor connector pin B & E. Check for 5 volts on sensor connector pin A & D. Check for 0.5 to 3 volts on sensor connector pin F and 0.25 to 1.5 on C. Refer to the Service Manual for more details.