Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 01 (INTELLIGENT THROTTLE CONTROL (iTC)) INTELLIGENT THROTTLE CONTROL (iTC) SERVICE TOOLS Description Part Number Page DIAGNOSTIC HARNESS ............................................................... 529 036 179 ......................................... 215 FLUKE 115 MULTIMETER ............................................................ 529 035 868 .................................215, 217 SERVICE PRODUCTS Description Part Number Page DIELECTRIC GREASE ................................................................... 293 550 004 .........................................

218 GENERAL SYSTEM DESCRIPTION The iTC is an electronic throttle control system that includes a cableless throttle control located on the RH side of handlebar, an electric throttle ac- tuator (ETA) located on the throttle body and the engine control module (ECM). The iTC is often re- ferred to as a "throttle by wire" system. sdd2009-001-030_b 1. Throttle body 2. Throttle actuator The throttle lever operates the throttle accelera- tor sensor (TAS). It is a double output hall effect sensor. The redundancy is used for security pur- poses. The throttle actuator (ETA) is a DC motor on the throttle body that regulates the throttle plate via a drive gear.

Pulse width modulation (PWM) is used to control the motor. In the throttle body, there is a double throttle position sensor (TPS). The redun- dancy is used for security purposes. The TPS is a potentiometer that supplies the ECM the actual angle position of the throttle plate. According to the torque demand from the TAS, the ECM powers the ETA motor which is rotated to open or close the throttle plate. When the ECM acknowledges that the throttle plate reached the targeted opening through the TPS, the ECM stops the throttle actuator to this position.

The iTC allows the throttle actuator to be moved ir- respective of the accelerator sensor position since it is not directly linked by a throttle cable. sdd2009-001-031_a 1. Throttle lever 2. Throttle accelerator sensor (TAS) smr2009-050 213