Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 01 (INTELLIGENT THROTTLE CONTROL (iTC)) While the throttle lever might be fully depressed and held, the ECM could close the throttle plate, instead of opening it, if the iBR lever were de- pressed. Then, the ECM could open the throttle plate to accelerate the engine to increase the brak- ing effect. All those different throttle plate move- ments could be achieved while the throttle lever was still fully depressed. This is one of the great flexibility of the iTC. The use of the iTC allows these additional engine modes of operation. the driver initiates a full turn. When handlebar is brought back to its center position, the throttle reverts to idle.

The throttle plate will open and close as necessary to assist the steering. Limitations The O.T.A.S. system cannot help maintaining con- trol or prevent collisions in all situations. PROCEDURES Learning and Rental Keys Learning and Rental keys limit the watercraft ma- ximum speed. The full stroke of the throttle lever is used while only a partial stroke of the throttle plate is achieved. Therefore, greater throttle lever movement is used while a smaller engine speed variation is applied through the throttle actuator. This permits a more accurate and easier throttle operation to control the engine within a maximum speed for a learner.

THROTTLE ACCELERATOR SENSOR (TAS) General The throttle accelerator sensor (TAS) is a double hall effect sensor that sends a signal to the ECM which is proportional to the throttle lever angle. Cruise Control Cruise control allows the operator to set a desired maximum speed of the watercraft when operat- ing above 3800 RPM. Cruise control limits watercraft speed but does not maintain it. The operator must hold the throt- tle lever depressed to maintain forward speed, unlike an automotive type cruise control which maintains a constant speed while throttle pedal is released.

As the throttle lever is kept fully depressed, the throttle plate will open and close as necessary to maintain the maximum set speed. sdd2009-001-031_a 1. Throttle lever 2. Throttle accelerator sensor (TAS) First ensure the throttle lever works adequately. Fully depress lever then release it. It must reach the wide open position and return to the idle po- sition freely when released. Otherwise, refer to STEERING SYSTEM for an inspection. Slow Speed Mode Slow speed mode is a function of cruise control which allows the operator to adjust and set idle speed corresponding to a watercraft speed of 1.6 km/h to 8 km/h (1 MPH to 5 MPH).

The throt- tle lever should not be depressed while operating in slow speed mode. The throttle plate will open and close as necessary to maintain the set speed. TAS Voltage Test Check the voltage of the throttle accelerator sen- sor as follows. Lift suspension using the iS up button to gain ac- cess. NOTE: If more height is required or if the iS can- not be used, manually lift suspension by the an- chor points close to handlebar and safely lock in this position. Do not lift the watercraft from the anchor points. From under the moving deck steering area, dis- connect the 8-pin and the 12-pin connectors. O.T.A.S. TM System (Off-Throttle Assisted Steering) The O.T.A.S.

(Off-Throttle Assisted Steering) system provides additional maneuverability in off-throttle situations. The O.T.A.S. system is electronically activated and slightly increases engine speed under a pre- defined RPM when 214 smr2009-050