Section 04 FUEL SYSTEM Subsection 01 (INTELLIGENT THROTTLE CONTROL (iTC)) smr2009-042-005_c 1. 8-pin connector 2. 12-pin connector smr2009-030-033_a Test on the 12-pin Connector of Diagnostic Harness Connect the DIAGNOSTIC HARNESS (P/N 529 036 179) to make an in-line connection between the disconnected connectors. 529036179 NOTE: Plug only the connectors that have been disconnected. Install the D.E.S.S. key on its post. Briefly press the START button to wake up the ECM. Use the FLUKE 115 MULTIMETER (P/N 529 035 868) and select Vdc. Measure the voltage readings on the installed di- agnostic harness connector as follows.
smr2009-030-033_b Test Results If voltage is as per specification, the TAS sensor is functional. If voltage is out of specification, check continuity of all wires between the ECM and the sensor. If continuity is good, replace sensor. Reinstall removed components. Test on the 8-pin Connector of Diagnostic Harness TAS Replacement Remove steering cover. Refer to STEERING SYS- TEM. Disconnect connector from TAS sensor. Pry out lock tabs of sensor and pull out sensor. smr2009-050 215 12-PIN CONNECTOR IDLE POSITION WIDE OPEN POSITION PIN VOLTAGE (Vdc) 10 11 4.9 - 5.1 11 12 0.4 - 0.6 2.9 - 3.1 8-PIN CONNECTOR IDLE POSITION WIDE OPEN POSITION PIN VOLTAGE (Vdc) 6 7 4.9 - 5.1 7 8 0.15 - 0.35 1.4 - 1.6