Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) smr2009-030-010_a If measurement is out of specification, check ground bus bar in fuse box #2 and continuity of its wires and connections with the engine grounds. Also check battery ground and engine grounds. smr2009-016-026_b LH SIDE OF ENGINE 1. Battery ground cable 2. Exhaust manifold water inlet fitting If everything tests good and ECM does not power up, try a new ECM. Refer to ECM RE- PLACEMENT. ECM Removal NOTE: If a new ECM is to be installed, first read the procedures in the ECM REPLACEMENT in this subsection. Disconnect battery cables.

WARNING Battery BLACK negative cable must always be disconnected first and connected last. smr2009-027-010_e 1. Ground bus bar in fuse box #2 Disconnect both ECM connectors from ECM. Unscrew all retaining screws and remove the en- gine ECM from intake manifold. smr2009-016-011_a FRONT OF ENGINE 1. Engine grounds smr2009-030-025_b 1. ECM 2. Retaining screws ECM Installation Reverse removal procedure but pay attention to the following. Install ECM to the engine. 226 smr2009-030