Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) Relay and wiring. Refer to POWER DISTRIBU- TION ECM power supply wires and ground wires. See below. ECM Power Supply Test Remove cover of fuse box #2 (FB). Refer to POWER DISTRIBUTION subsection. Install the D.E.S.S. key on its post. Briefly press the START button to wake up the ECM. Use the FLUKE 115 MULTIMETER (P/N 529 035 868) and select Vdc. Probe the fuse F20 as shown. NOTE: This will validate the fuse at the same time. smr2009-030-010 3. Use the FLUKE 115 MULTIMETER (P/N 529 035 868) and select . 4. Probe terminals as follows. smr2009-030-009_b ECM Ground Test Disconnect B connector from ECM.
Install ECM ADAPTER TOOL (P/N 529 036 166) on ECM connector. Use the FLUKE 115 MULTIMETER (P/N 529 035 868) and select . Probe adapter terminals as follows. smr2009-030-009_a If voltage is not as per specification, check the wiring and connections between relay output and F20 output. Refer to WIRING DIAGRAM. If voltage is as per specification, check the conti- nuity of wiring and connections between FB2 and ECM as follows. 1. Disconnect B connector from ECM. 2. Install ECM ADAPTER TOOL (P/N 529 036 166) on ECM connector.
smr2009-030 225 FUSE BOX #2 ECM ADAPTER RESISTANCE Terminal D4 Pin B-M4 Close to 0 FUSE BOX #2 BATTERY POST VOLTAGE Fuse F20 terminal at D4 Ground Battery voltage ECM ADAPTER BATTERY POST RESISTANCE Pins B-L1, B-M2 and B-M3 Ground Close to 0 (continuity)