Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) ECM Power Supply Troubleshooting Relay contacts open and power to the ECM is cut. Power is cut on all the electrical system except the GPS supply in the information center. When engine is running and the D.E.S.S. key is removed from its post: ECM stops the engine. After 5 seconds, the information center turns off. After 10 seconds, ECM pin B-H2 removes the ground to the relay coil. Relay contacts open and power to the ECM is cut. Power is cut on all the electrical system except the GPS supply in the information center. When engine is not running and the START button is briefly pressed without starting engine:

The information center turns on and remains on until ECM turns off. When there is no D.E.S.S. key installed, ECM pin B-H2 removes the ground to the relay coil after 3 minutes. When a D.E.S.S. key installed, ECM pin B-H2 removes the ground to the relay coil after 4 min- utes. Relay contacts open and power to the ECM is cut. Power is cut on all the electrical system except the GPS supply in the information center. ECM Power Supply Diagram 6;G 6 6 9 6;G ; / E1 ; ;9 ; ; 6;G 8!/0 ; 6;G 6 6 D D D: ; 6;G ; / E1 D / + , 6;G 6 6 D ; 㜻 + ,1 . + -/! '/3 . 䐻 ; 5 ;5 ; 6;G ; / - 1 (5 5 6; H 6 smr2009-030-001_en ECM Wake Up Basics When the START button is depressed:

ECM pin B-D1 receives current from battery via the START switch. ECM is woken up. ECM pin B-H2 provides a ground to the relay coil in fuse box #2 (FB). The relay contacts close and fully powers the ECM at pin B-M4. The relay also powers the other components in the electrical system. ECM pin B-E4 monitors if a key is present. When a key is installed, the magnet in the key closes the reed switches in the D.E.S.S. post and the ECM pin B-F2 provides a ground. This tell the ECM a key is present. ECM pin B-B2 reads the D.E.S.S. key and de- termines if it is valid. If so, the engine can be started. ECM Power Supply Validation Briefly press the START button.

This should wake up the ECM and continuously activate the relay in FB#2. QUICK INDICATION THAT ECM IS NOT POWERED (assuming the observed component is working) Information center does not turn on. Fuel pump does not turn on for approximately 5 seconds. Throttle actuator does not initialize. ECM Shut Down Basics When engine is running and Stop button is de- pressed: ECM stops the engine. After 5 seconds, the information center turns off. After 60 seconds, ECM pin B-H2 removes the ground to the relay coil. If ECM does not turn on, check the following: Fuses F16, F17 and F20 in fuse box #2 (FB) Battery voltage.

Refer to CHARGING SYSTEM The power bus bars in FB#1 and FB#2 The ground bus bar in FB#2 224 smr2009-030 ;/0