Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) It is important to ensure that the mechanical in- tegrity of the engine/propulsion system are intact. For diagnostics purposes, use B.U.D.S. software. See COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE subsection. After a problem has been solved, ensure to clear the fault(s) in the ECM using the B.U.D.S. soft- ware. PROCEDURES ENGINE CONTROL MODULE (ECM) ECM Connector Access NOTE: For connector information, cleaning and probing, refer to WIRING DIAGRAM subsection. Open seat. Remove rear ventilation box. Refer to AIR INTAKE SYSTEM. Remove deck extension. Refer to BODY.
WARNING All electrical actuators and electronic mod- ules are powered as soon as the START button is depressed. Always disconnect the battery prior to disconnecting any electrical or electronic parts. Never use a battery charger to substitute tem- porarily the battery, as it may cause the ECM to work erratically or not to work at all. Check related-circuit fuse solidity and condition with an ohmmeter. Visual inspection could lead to false results. IMPORTANT: Use genuine wires only. Otherwise wires will not fit properly. Electrical Related Problems It is important to check the following in the elec- trical system:
Battery voltage Fuses Bus bar condition in fuse boxes Ground connections Wiring connectors. Ensure that all electronic components are gen- uine. Any modification on the wiring harness may lead to generate fault codes or bad operation. smr2009-030-025_a 1. ECM 2. ECM connectors ECM Connector Identification There are 2 connectors connected to the ECM. The engine harness female connector is con- nected on the module male connector A and the vehicle system control harness female connector is connected to the module male connector B. The ECM connectors have 48 pins. Electrical Connections Pay particular attention to ensure that terminals and pins are not out of their connectors or out of shape.
When probing terminals, pay attention not to bend the terminal as this could bring a loose connection that would be difficult to troubleshoot. smr2009-027-005 ECM CONNECTORS smr2009-030 223