Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) Use a DIGITAL INDUCTION TACHOMETER (P/N 529 014 500) . Install the D.E.S.S. key on its post. Briefly press the START button to wake up the ECM. Engine must not crank. In B.U.D.S., click on the Reset button. 529014500 Wrap the tachometer's wire a few times around the protruding part of ignition coil. smr2009-030-002_a SETTING AND ECM TABS 1. Click Reset button The following message will confirm the operation. smr2009-030-003 TYPICAL Reset is completed. NOTE: It is not necessary to click on the Write button in B.U.D.S. Exit B.U.D.S. NOTE:

If throttle valve was not within the al- lowed range while resetting the Closed Throttle , nothing would tell you that it was wrong. No error message would be displayed. However, a fault code would be set when engine would be started. Start engine and make sure it operates normally through its full engine RPM range. Check for fault codes in B.U.D.S. If fault a code related to the throttle actuator appears, clear it then do the reset closed throttle procedure again. To clear faults, refer to MONITORING SYSTEM AND FAULT CODES subsection. Start engine to verify engine RPM. NOTE: If idle speed is not within specifications, check if there is any occurred or active fault code(s).

If not, proceed with the Closed Throttle reset. If idle speed is still not adequate, there is probably a mechanical problem. CLOSED THROTTLE RESET General Information This operation performs a reset of the TPS values of the throttle body in the ECM. Closed throttle reset must be done only when: Replacing throttle body. Replacing ECM. TROUBLESHOOTING Closed Throttle Reset Procedure Use the B.U.D.S. software to perform this set- ting. Refer to COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE subsection. DIAGNOSTIC TIPS Engine problems are not necessarily related to the fuel injection system. 222 smr2009-030