Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) Flame Arrester The flame arrester is a tube inside the intake mani- fold. It prevents flames leaving through the intake system if the engine backfires. EFI Sensors The ECM reads the inputs from the sensors, makes computations, uses pre-determined pa- rameters and activates the outputs (injectors, ignition coils etc.). Signals from sensors are used by the ECM to determine the injection and ignition parameters (such as fuel maps required for optimum air-fuel ratio). smr2009-030-019_a 1. Supercharger 2. Supercharger inlet 3. Supercharger outlet 4. Intercooler 5. Intercooler air inlet warm air from supercharger 6.
Intercooler air outlet cooled air 7. Throttle body 8. Cooling water outlet warmed water 9. Intercooler cooling water inlet cold water Fuel Rail One fuel rail is mounted on the intake manifold. The fuel rail ensures all the time, that enough fuel can be delivered to the fuel injectors. The fuel rail is fed by the fuel pump with the properly regulated fuel pressure. Throttle Body A 62 mm throttle body is mounted on the intake manifold. Fitted on the throttle body, an electric throttle actuator (ETA) allows the ECM to control the throttle plate opening to regulate the engine speed. Air for combustion is drawn at the back of the en- gine by a mechanically-driven supercharger.
The compressed air flows through the throttle body and is controlled by a throttle plate. The air con- tinues through the intake manifold and goes into the cylinder head. Fuel Injectors Three fuel injectors are used to inject fuel into the intake ports of the cylinder head. One injector is used per cylinder. Engine Wiring Harness The engine wiring harness is connected to the vehicle harness through the engine connector. It connects all sensors, injectors and ignition coils. Intake Manifold The intake manifold is mounted on the side of the cylinder block. It provides support for the fuel in- jectors, the fuel rail, the ECM, the flame arrester and the throttle body.
The intake manifold is a res- onator between the throttle body and the cylinder head. smr2009-030-039_a 1. Engine harness 2. Engine connector ADJUSTMENT smr2009-030-020_a INTAKE MANIFOLD 1. Engine Control Module (ECM) 2. Fuel rail 3. Injector 4. Throttle body 5. Ignition coil 6. Manifold absolute pressure sensor (MAPS) 7. Manifold air temperature sensor (MATS) IDLE SPEED The idle speed is not adjustable. The ECM con- trols the idle speed of the engine with the iTC. If desired, the engine RPM can be measured fol- lowing this procedure: smr2009-030 221