Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) WARNING If any gasoline leak and/or odor are present, do not start the engine. Repair the leak. SYSTEM DESCRIPTION The electronic fuel injection system (EFI) on this engine is based on the open-loop Bosch ME-Motronic system. It comprises all the sen- sors for detecting the ongoing operating from the engine and watercraft and comprises all the actuators that perform the required adjustment to the engine. The ME-Motronic uses an electroni- cally controlled throttle valve. There is no idle air control valve (IACV). Also, this system introduces torque management functions. From the input signals (e.g.

throttle lever, iBR lever), the ECM acknowledges the driver demand and convert it to engine operation through a torque requirement by calculation of several vari- ables. Then, the ECM controls the iTC (intelligent Throttle Control), the injection system and the ignition system to meet the torque requirement. The ECM manages several engine torque require- ments to control engine operation such as to deliv- ering engine performance, fuel economy, meeting emission regulations, limiting engine speed etc.

Since the ECM has several torque requirements at the same time and even contradictory demands (if the throttle lever is fully depressed and the iBR lever is fully squeezed for example) it must priori- tize the most important requirement according to predefined conditions and then applies the proper action by triggering the actuators. smr2009-030-017_a 1. Air entry behind rubber baffle 2. Air intake silencer smr2009-030-018_a AIR INTAKE SILENCER LIFTED FOR CLARITY 1. Air intake silencer 2. Air duct 3. Supercharger An intercooler cools down the air from the super- charger. Intercooler The intercooler is mounted externally of intake manifold and is located above drive shaft.

Air that exits the supercharger has been warmed up by the air compression. The air that enters the intercooler is cooled down by circulating across small tubes in which cooling water flows. The cooling water is supplied by the jet pump. The end result is that the air density is higher and you get more air into the engine. Air Induction Air Intake Silencer Air is drawn through the air intake silencer located above rear part of engine. The air entry is above the front part of engine and a rubber baffle is used to prevent the ingestion of water. If water was drawn, baffles inside the air intake silencer would separate the water from the air.

Water would then flow out through a drain valve at bottom of the air intake silencer. An air duct is used to bring the air to the super- charger. 220 smr2009-030