Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) ELECTRONIC FUEL INJECTION (EFI) SERVICE TOOLS Description Part Number Page DIGITAL INDUCTION TACHOMETER ........................................... 529 014 500 ......................................... 222 ECM ADAPTER TOOL................................................................... 529 036 166 ........................225, 235, 242, 246–247, 249, 251 FLUKE 115 MULTIMETER ............................................................ 529 035 868 ........................ 225, 234–235, 240, 244, 246, 248 FUEL HOSE DISCONNECT TOOL ................................................
529 036 037 ......................................... 230 SERVICE TOOLS OTHER SUPPLIER Description Part Number Page FLUKE RIGID BACK PROBE ......................................................... TP88 ......................................... 244 SERVICE PRODUCTS Description Part Number Page LOCTITE 243 (BLUE)..................................................................... 293 800 060 .................................231, 242 LOCTITE 518 ................................................................................. 293 800 038 .........................................
250 GENERAL When the repair is completed, ensure that hoses from fuel rail going to fuel pump are properly se- cured in their supports. Then, pressurize the fuel system. Refer to FUEL TANK AND FUEL PUMP subsection. Use the B.U.D.S. software to release the fuel pressure in the system. Refer to FUEL SYSTEM. WARNING Fuel lines remain under pressure at all times. Always proceed with care and use appropri- ate safety equipment when working on pres- surized fuel system. Wear safety glasses. Do not allow fuel to spill on hot engine parts and/or on electrical connectors. Proceed with care when removing/installing high pressure test equipment or disconnecting fuel line connections. Use the B.U.D.S.
software to release fuel pressure prior to removing a hose. Cover the fuel line connection with an absorbent shop rag. Slowly disconnect the fuel hose to minimize spilling. Wipe off any fuel spillage in the bilge. Fuel is flammable and explosive under certain conditions. Al- ways work in a well ventilated area. Always disconnect battery prior to working on the fuel system. WARNING Ensure to verify fuel line connections for damage and that NO fuel line is discon- nected prior to pressing the START button. Always perform the high pressure test if any component has been removed.
To check fuel rail for leaks, first pressurize the system then spray soapy water on all hose con- nections, regulators and injectors. Air bubbles will show the leaking area. Check also for leaking fuel or fuel odor. WARNING Thoroughly rinse an dry fuel hoses from the soapy solution after the leak test. Failure to clean fuel lines from soap might lead to fuel line deterioration over time. WARNING Never use a hose pincher on high pressure hoses. smr2009-030 219