Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) FUEL INJECTOR Fuel Injector Operation Test with B.U.D.S. (Dynamic) 1. Connect B.U.D.S. Refer to COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE. 2. Start engine. 3. Using the B.U.D.S. software, shut down each engine cylinder, one at a time. smr2009-030-011_b 1. New locking ties Fuel Rail Hose Connection 1. Apply engine oil on O-rings of fitting. mmr2009-120-006_a MONITORING AND ECM TABS 1. Click on the desired cylinder number If the engine RPM drops when clicking on a cylin- der, the injector and the ignition of this cylinder are working.

If the engine RPM does not drop when clicking on a cylinder, this cylinder is not working properly. Check the following: Fuel injector operation. Refer to FUEL INJEC- TOR OPERATION TEST. Spark plug and ignition coil. Refer to IGNITION SYSTEM. Engine condition. mmr2009-121-022_a 1. Apply oil on O-rings 2. Connect fuel hose to fuel rail. IMPORTANT: Push fuel hose fitting on fuel rail un- til you hear a "click". Try pulling fuel hose to ensure fitting is properly locked. Pressurize the fuel system. Refer to FUEL SYS- TEM PRESSURIZATION in FUEL TANK AND FUEL PUMP subsection. Fuel Injector Operation Test with B.U.D.S.

(Static) NOTICE After fuel injector activation us- ing B.U.D.S., always crank engine in drowned mode to ventilate engine to prevent a potential backfire due to fuel accumulation in engine. WARNING Failure to pressurize the fuel system may re- sult in severe injury or a life threatening situ- ation should a leak occur. Connect B.U.D.S. Refer to COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE. Install D.E.S.S. key on its post. Briefly press the START button to wake up the ECM. Do not start engine. Energize the desired fuel injector in B.U.D.S. 3. Reinstall all remaining removed parts. 232 smr2009-030