Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) 5. Fuel pressure must be within specification. Re- fer to FUEL TANK AND FUEL PUMP subsec- tion. Re-activate fuel pump as necessary. 6. In B.U.D.S., energize the fuel injector no. 1 . smr2009-030-013_a ACTIVATION AND ECM TABS 1. Injector of cylinder no. 1 shown Listen to the injector. If you can hear the injector, it validates its oper- ation. Carry out the FUEL INJECTOR BALANCE TEST. If you do not hear the injector, carry out the INJEC- TOR INPUT VOLTAGE TEST. smr2009-030-013_a ACTIVATION AND ECM TABS 1. Injector of cylinder no. 1 shown 7. Record the fuel pressure drop for injector no. 1 . 8.
In B.U.D.S., click the Fuel Pump button to ac- tivate fuel pump. Fuel Injector Balance Test with B.U.D.S. NOTICE After fuel injector activation us- ing B.U.D.S., always crank engine in drowned mode to ventilate engine to prevent a potential backfire due to fuel accumulation in engine. 1. Install a fuel pressure gauge as described in FUEL PUMP PRESSURE TEST of FUEL TANK AND FUEL PUMP subsection. 2. Connect B.U.D.S. Refer to COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE. 3. Install D.E.S.S. key on its post. Briefly press the START button to wake up the ECM. Do not start engine. 4. In B.U.D.S., click the Fuel Pump button to ac- tivate fuel pump. smr2009-030-014_a ACTIVATION AND ECM TABS 1.
Fuel pump 9. Repeat the procedure for fuel injectors no. 2 and no. 3 and record their pressure drops. 10. The maximum fuel pressure drop between in- jectors should not exceed the following spec- ification: MAXIMUM FUEL PRESSURE DROP ALLOWED BETWEEN FUEL INJECTORS 10 kPa (1.5 PSI) 11. If pressure drop of any fuel injector is greater than the specification, replace that injector then repeat the test. 12. Use the valve on the fuel pressure gauge to re- lease the pressure (if so equipped). Remove fuel pressure gauge and reinstall removed parts. smr2009-030-014_a ACTIVATION AND ECM TABS 1. Fuel pump smr2009-030 233