Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) Fuel Injector Input Voltage Test Open seat. Remove rear ventilation box. Refer to AIR INTAKE SYSTEM. Disconnect fuel injector connectors. NOTE: Push against tab underneath connector as shown to unlock it. smr2009-030-029_a If input voltage is good, carry out the INJECTOR CONTROL CIRCUIT TEST. If input voltage is not good, check continuity be- tween fuse box #1 and injector as follows. Remove cover of fuse box 1. Refer to POWER DISTRIBUTION subsection. Remove the long bus bar. smr2009-030-028_a PUSH HERE TO UNLOCK smr2009-027-011_f 1. Long bus bar Use the FLUKE 115 MULTIMETER (P/N 529 035 868) and select .

Read resistance of the desired injector circuit. smr2009-030-011_a 1. Fuel injector connectors Install D.E.S.S. key on its post. Briefly press the START button to wake up the ECM. Use the FLUKE 115 MULTIMETER (P/N 529 035 868) and select Vdc. Read voltage of the desired injector. 234 smr2009-030 INJECTOR INJECTOR CONNECTOR FUSE BOX #1 MEASUREMENT 1 (rear) VIOLET wire with a tracer Terminal C11 Close to 0 2 Terminal C9 3 Terminal C7 INJECTOR CONNECTOR MEASUREMENT VIOLET wire with a tracer and battery ground Battery voltage