Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) Disconnect the ECM A connector. Install ECM ADAPTER TOOL (P/N 529 036 166) on ECM connector. Remove the long bus bar from fuse box #1. smr2009-030-015_j If continuity is good, wiring and connectors are functional. If continuity is faulty, repair/replace wiring from fuse box terminal to injector. Reinstall bus bar and cover. smr2009-027-011_f 1. Long bus bar Fuel Injector Control Circuit Test Disconnect ECM A connector. Install ECM ADAPTER TOOL (P/N 529 036 166) on ECM connector. Use the FLUKE 115 MULTIMETER (P/N 529 035 868) and select . Probe terminals as follows.
Use the FLUKE 115 MULTIMETER (P/N 529 035 868) and select . Measure resistance value between terminals as follows. smr2009-030-015_i If resistance value is correct, injector coil is in good condition. If resistance value is incorrect, repeat test at injec- tor connector. Reinstall bus bar and cover. If control circuit is faulty, repair/replace wiring/con- nectors. If control circuit and all tests applicable to the in- jector are good, try a new ECM. Refer to ECM. smr2009-030-010_c Fuel Injector Resistance Test (at Component) Remove injector connector and check resistance value between injector pins as follows. Fuel Injector Resistance Test (at ECM Connector) Reconnect the injector connector.
smr2009-030 235 INJECTOR FUSE BOX #1 TERMINAL ECM ADAPTER PIN RESISTANCE @ 20°C (68°F) 1 C11 A-B3 11.4 - 12.6 2 C9 A-K1 3 C7 A-J1 INJECTOR ECM ADAPTER INJECTOR MEASUREMENT 1 (rear) Pin A-B3 BROWN wire with a tracer Close to 0 2 Pin A-K1 3 Pin A- J1