Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) Insert the fuel injector in place on fuel rail. Secure injector to fuel rail with its clip. Install fuel rail. Refer to FUEL RAIL in this subsec- tion. THROTTLE BODY smr2009-030-030_a If readings are out of specifications, replace injec- tor. If readings are good, repair/replace wiring/connec- tors from ECM to injector. smr2009-030-016_a 1. Throttle body 2. Throttle plate 3. Throttle actuator (electric motor inside) 4. Throttle position sensor (TPS) (inside) Fuel Injector Removal Remove fuel rail. Refer to FUEL RAIL in this sub- section. Remove the injector clip.
To disconnect connector from throttle body, press connector tab as shown. FUEL RAIL ASSEMBLY 1. Fuel injector 2. Injector clip 3. O-ring smr2009-030-031_a PRESS HERE TO UNLOCK Pull out the fuel injector from the fuel rail. Fuel Injector Installation Reverse the removal procedure. Paying attention to the following details. If you reinstall a used injector, carefully inspect O-ring condition before reinstallation. Replace O-ring with a new one if damaged. Apply a thin film of engine oil to O-rings. 236 smr2009-030 INJECTOR PIN RESISTANCE @ 20°C (68°F) 1 2 See above