Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) Throttle-Body Faults and Effects NOTE: Among other things, a weak or broken spring and a sticky throttle plate (carbon build-up, dried salt water etc) are validated by the throttle body diagnostic mode. smr2009-030-032_a CONNECTOR PIN-OUT Throttle Actuator Operating Positions Two torsional springs are connected with the throttle plate. A main spring and another one in a plunger mechanism. When there is no power on the throttle actuator (ETA), the plunger mechanism maintains the throt- tle plate to a rest position. This also serves as the limp home position.

When the throttle plate is opened by the ETA, it acts against the main spring. If the ETA failed, the return spring would bring back the throttle plate to the limp home position. Throttle Body Lubrication No lubrication is required. Throttle Body Cleaning To gain access to throttle body, remove the re- quired parts as described in THROTTLE BODY RE- MOVAL. Check throttle body cleanliness using a flashlight. Fully open throttle plate and verify: Throttle body bore Throttle plate edge. Look for: Dirt Oily surfaces Carbon deposits on throttle plate and the sur- rounding bore. Clean as necessary. Use a throttle body cleaner such as GUNK INTAKE MEDIC or the equivalent.

smr2009-030 237 FAULT EFFECT Partial failure of TAS sensor (one internal sensor only) Limp home mode. Engine speed limited to idle. ECM will use the remaining TAS sensor. Fault code set and beeper activated to emit warning signals. Check engine light is turned ON. Driveability could be reset by releasing and reapplying the throttle. Complete failure of TAS sensor (both internal sensors) Limp home mode. Engine speed limited to 2500 RPM. Fault code set and beeper activated to emit warning signals. Check engine light is turned ON. Any throttle body failure Limp home mode. Engine speed limited to 2500 RPM. Engine speed can still be increased up to 3200 RPM using the throttle lever.

Fault code set and beeper activated to emit warning signals. Check engine light is turned ON. NOTE: When one of these fault is active, OTAS and iBR will continue to monitor their input signals. However, since the engine speed is limited, the OTAS will not be activated. Also, since the ECM cannot control the throttle body, the iBR might come in fault because the ECM does not react to his specific torque request. It all depends on the circumstances when the iBR is applied. (vehicle and engine speed will be a factor). ECM ENGINE THROTTLE BODY OFF Stopped Throttle actuator: Off. Throttle plate: Rest position, maintained opened at approximately 8° (1). This is also the limp home position.

ON Not started Throttle actuator: On. Throttle plate: Moves from the rest position to approximately 14°. It then moves back to the rest position. This is the diagnostic mode where the rest position, actuator opening force to overcome the return springs and the motor return rate are monitored. If any of these parameter are out of range, a fault code is initiated. ON Started. Normal operation at idle Throttle actuator: On. Throttle plate: Moves from the rest position to idle position (approximately 1-3°) according to ECM injection and ignition maps. Throttle plate is opened and closed as necessary to control the idle speed. ON Started. Normal operation at various RPM Throttle actuator: On.

Throttle plate: Opens and closes according to ECM torque management priorities. (1) Degree values are given from the fully closed position.