Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) NOTICE Only use an appropriate throttle body cleaner that will not damage O-rings and EFI sensors. WARNING Keep your fingers out of the throttle plate area while the ECM turns on. The throttle actuator will cycle. This could cause seri- ous finger injuries as throttle plate quickly moves. WARNING Use the product in well ventilated area. Refer to product manufacturer's warnings. Wipe off any product leakage in bilge. Throttle plate should quickly move from the rest position to a partially open position (approximately 14°). It will then move back to the rest position.
Ask someone to gradually and evenly depress and then release the same way the throttle lever. Throttle plate should open then close according to throttle lever position. If any test failed, proceed with the STATIC TESTS. To avoid getting dirt into engine, spray cleaner on a clean rag (outside the bilge) then rub rag against throttle plate and bore. A toothbrush works well too. WARNING First ensure ECM is off. Otherwise, if ECM would turn off, it would quickly close the throttle plate and this could cause serious finger injuries if you were working in this area. Static Tests WARNING First ensure ECM is off.
Otherwise, if ECM would turn off, it would quickly close the throttle plate and this could cause serious finger injuries if you wsere working in this area. Manually open throttle and hold fully open to reach all surfaces. WARNING Ensure nobody presses the START button. The ECM would turn on and throttle actuator would cycle. This could cause serious finger injuries as throttle plate quickly moves. WARNING During the test, ensure nobody presses the START button. The ECM would turn on and throttle actuator would cycle. This could cause serious finger injuries as throttle plate quickly moves. To remove residual dirt, spray cleaner on throttle plate and on bore. Reinstall removed parts.
Check that the throttle plate opens smoothly when manually pushing on throttle plate in throt- tle body. Throttle Body Inspection Always check for corroded terminals or damaged wiring when diagnosing throttle body. Dynamic Tests To gain access to throttle body, remove the re- quired parts as described in THROTTLE BODY RE- MOVAL. Look at throttle plate when the engine is stopped. Throttle plate should be in the rest position (slightly opened). Install the D.E.S.S. key on its post. Ask someone to briefly press the START button to wake up the ECM while watching the throttle plate. Do not start engine. smr2009-030-016_b 1. Push here to open 238 smr2009-030