Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) Throttle plate must fully open and when released, must return freely to the rest position (slightly opened). Push throttle plate where shown. It must com- pletely close and when released, freely return to the rest position (slightly opened). smr2009-030-024_a 1. Throttle body 2. Inlet hose 3. Connector 4. Remove retaining screws from throttle body. smr2009-030-016_c 1. Push here to close If throttle plate does not move smoothly or does not return freely to the position, the problem is mechanical. Check for salt accumulation on throt- tle plate shaft. It may also be an actuator or gear problem.
Replace throttle body as necessary. If throttle plate operates normally, the problem is electrical. Check throttle actuator (ETA) wiring continuity, throttle position sensor (TPS) and throttle accelerator sensor (TAS). smr2009-030-022_a 1. Throttle body 2. Screws 5. Pull throttle body out. Installation Installation of the new throttle body is the reverse of the removal procedure. However, pay attention to the following. Torque retaining screws in a criss-cross sequence to 9 N•m (80 lbf• in ). Perform the Closed Throttle reset. See proce- dure in ADJUSTMENTS. WARNING Replace throttle body when throttle plate does not return properly. Throttle Body Replacement Removal Open seat.
Remove rear ventilation box. Refer to AIR INTAKE SYSTEM. Remove deck extension. Refer to BODY. 1. Lift suspension using the iS up button to gain access. NOTE: If more height is required or if the iS can- not be used, manually lift suspension by the an- chor points close to handlebar and safely block in this position. Do not lift the watercraft from the anchor points. 2. Disconnect inlet hose from throttle body. 3. Disconnect throttle body connector. TPS (THROTTLE POSITION SENSOR) General NOTE: The TPS is part of the throttle body. The throttle position sensor (TPS) is a double po- tentiometer that sends a signal to the ECM which is proportional to the throttle plate angle.
The TPS is located inside the throttle body. TPS Wear Test While engine is not running, activate throttle and pay attention for smooth operation without phys- ical stops. smr2009-030 239