Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) Install the D.E.S.S. key on its post. Briefly press the START button to wake up the ECM. Do not start engine. Connect B.U.D.S. Refer to COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE. In B.U.D.S., select the Monitoring tab then the ECM tab. Use the Throttle Opening . smr2009-030-016_b 1. Push here Check needle movement again. If needle moves as expected, check the throttle accelerator sensor (TAS) of throttle lever. Refer to THROTTLE ACCELERATOR SENSOR (TAS) in this subsection. If needle does not move as expected, perform the TPS VOLTAGE TEST and the TPS RESIS- TANCE TEST in this subsection.

mmr2009-120-001 MONITORING AND ECM TABS Slowly and regularly depress the throttle lever. Observe the needle movement. NOTE: An initial slight delay after the throttle lever is depressed and before the needle starts to move is normal. Needle should change gradually and regularly as you move the throttle lever. If the needle “sticks”, bounces or suddenly drops, it may indi- cates a worn TPS that needs to be replaced. If the needle behavior is not as expected, perform the following. Manually move the throttle plate in throttle body using a screwdriver (without sharp tip). TPS Resistance Test To gain access to throttle body, remove the re- quired parts as described in THROTTLE BODY RE- MOVAL.

Ensure the throttle body connector is plugged. Disconnect the ECM connector A from the ECM. Use the FLUKE 115 MULTIMETER (P/N 529 035 868) and select . Probe circuit as per following table while using your hand to manually move throttle plate. WARNING Do not move throttle plate with your fingers. Otherwise, if ECM would turn off, it would quickly close the throttle plate and this could cause serious finger injuries if you were working in this area. 240 smr2009-030 ECM ADAPTER FULLY CLOSED THROTTLE PLATE (1) FULLY OPEN THROTTLE PLATE RESISTANCE ( ) PIN MIN. MAX. MIN. MAX.

A-A2 A-K4 875 1625 875 1625 A-A2 A-K3 954 1934 228 585 A-A2 A-F3 254 634 980 1983 A-K3 A-K4 228 585 954 1934 A-K3 A-F3 1385 2315 1385 2315 A-K4 A-F3 980 1983 254 634 (1) To obtain the fully closed position, it is necessary to push against throttle plate in throttle body with your hand and hold it in this position for the measurement.