Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) vmr2008-022-005_a If any resistance value is incorrect, check wire continuity between ECM and throttle body. If continuity is good, replace throttle body. If resistance values are correct, try a new ECM. Refer to ENGINE CONTROL MODULE (ECM) in this subsection. smr2008-023-016_a TYPICAL Install the D.E.S.S. key on its post. Briefly press the START button to wake up the ECM. Probe terminals while cranking, as shown. CRANKSHAFT POSITION SENSOR (CPS) smr2006-020-100_a TYPICAL 1. Crankshaft Position Sensor (CPS) NOTE: Take into account that a CPS fault can be triggered by a bent or missing trigger wheel tooth.
First check fault codes then CPS as per following procedure; if it tests good, verify trigger wheel teeth condition. Refer to PTO HOUSING AND MAGNETO in the ENGINE section. lmr2006-021-002_a TYPICAL CPS Resistance Test Disconnect CPS connector. Probe terminals as follows. CPS Voltage Test To gain access to the CPS, remove the required parts as described in CPS REPLACEMENT. Disconnect CPS connector. smr2009-030 241 CPS CONNECTOR MEASUREMENT PIN VOLTAGE 1 2 Approximately 2.3 Vac CPS CONNECTOR MEASUREMENT PIN RESISTANCE @ 20°C (68°F) 1 2 700 - 900