Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) Remove deck extension. Refer to BODY. Remove air intake silencer. Refer to AIR INTAKE SYSTEM. Drain oil from PTO housing. Refer to PTO HOUS- ING AND MAGNETO. NOTE: It is not necessary to drain oil from engine. Disconnect CPS connector. lmr2006-021-002_b TYPICAL If resistance is not within specifications, replace the CPS. If resistance tests good, reconnect the CPS and disconnect the ECM connector A on the ECM. Using a multimeter and the ECM ADAPTER TOOL (P/N 529 036 166) . Select and check circuit resistance as per table. smr2008-023-016_a TYPICAL Remove wire retaining clip if applicable. Remove CPS retaining screw.
vmr2008-022-005_a smr2006-020-100_b 1. Wire retaining clip 2. CPS retaining screw If resistance value is correct, check ECM. Refer to ENGINE CONTROL MODULE (ECM) in this sec- tion. If resistance value is incorrect, repair the connec- tors or replace the wiring harness between ECM connector and the CPS. Pull out CPS. Reverse procedure for installation. However, pay attention to the following. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on screw threads then torque to 9 N•m (80 lbf• in ). Refill engine oil and check oil level, refer to LUBRI- CATION SYSTEM subsection. CPS Replacement Open seat. Remove rear ventilation box. Refer to AIR INTAKE SYSTEM.
242 smr2009-030 ECM ADAPTER MEASUREMENT PIN RESISTANCE @ 20°C (68°F) A-H1 A-K2 See above