Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) Trigger Wheel Inspection Refer to PTO HOUSING AND MAGNETO in the ENGINE section. CAMSHAFT POSITION SENSOR (CAPS) smr2009-030-035_a If battery voltage is read, proceed with CAPS DY- NAMIC TEST further. If battery voltage is not read, probe circuit as shown. smr2006-020-057_a TYPICAL 1. CAPS CAPS Voltage Test (Harness Side) First check fuse F2 in fuse box #1 (FB). To gain access to the CAPS, remove the required parts as described in CAPS REPLACEMENT. Disconnect CAPS connector. smr2009-030-035_b smr2009-030-034_a 1.

CAPS connector If voltage is now read, check ground circuit be- tween CAPS pin 1 and ECM pin A-D4 for continu- ity. Repair wire/connector if defective. If voltage is still not read, check power supply cir- cuit for continuity as follows. Remove cover of fuse box #1. Refer to POWER DISTRIBUTION. Remove the long bus bar. Install D.E.S.S. key. Briefly press the START button to wake up the ECM. Probe terminals as shown. smr2009-030 243 CAPS CONNECTOR MEASUREMENT PIN VOLTAGE 3 1 Battery voltage CAPS CONNECTOR MEASUREMENT PIN VOLTAGE 3 Battery ground Battery voltage