Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) vmr2007-050-004 They can be inserted at the end of the standard probes of the FLUKE 115 MULTIMETER (P/N 529 035 868) . smr2009-027-011_f 1. Pull out Use the FLUKE 115 MULTIMETER (P/N 529 035 868) and select . Read resistance of the CAPS circuit. vmr2007-050-005 smr2009-030-015_e If continuity is good, wiring and connectors are functional. If continuity is faulty, repair/replace wiring from fuse box terminal to CAPS. Reinstall bus bar and cover. smr2007-021-010_a CAPS Dynamic Test To gain access to the CAPS, remove the required parts as described in CAPS REPLACEMENT. Remove CAPS sensor from engine.
Back-probe connector and read voltage as fol- lows. NOTE: To easily probe wire terminals through the back of their connectors, FLUKE RIGID BACK PROBE (P/N TP88) or equivalent can be used. 244 smr2009-030 FUSE BOX #1 CAPS CONNECTOR RESISTANCE TERMINAL PIN C10 3 Close to 0 (continuity) CAPS CONDITION CAPS CONNECTOR VOLTAGE Free 3 2 Close to 0 Vdc CAPS CONDITION CAPS CONNECTOR VOLTAGE Metallic object on sensor 3 2 Battery voltage