Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) smr2009-030-034_a 1. CAPS connector Unscrew the retaining screw. Pull out CAPS from engine. Install the CAPS. Ensure to reinstall O-ring. Apply Loctite 243 (blue) on thread and torque to 9 N•m (80 lbf• in ). smr2007-021-009_c 1. Metallic object If voltage is appropriate, check/repair wiring/con- nector between sensor and ECM. If it is good, check ECM. Refer to ENGINE CONTROL MOD- ULE (ECM). If voltage is wrong, try a new CAPS. MANIFOLD AIR TEMPERATURE SENSOR (MATS) CAPS Replacement Open seat. Remove rear ventilation box. Refer to AIR INTAKE SYSTEM. Remove deck extension. Refer to BODY. Remove air intake silencer.
Refer to AIR INTAKE SYSTEM. Detach CPS connector from its holder. smr2009-030-036_b 1. Manifold air temperature sensor (MATS) MATS Resistance Test To gain access to the MATS, remove the required parts as described in MATS REPLACEMENT. Disconnect the MATS connector. smr2008-023-016_a TYPICAL Disconnect CAPS connector. smr2009-030 245