Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) smr2009-030-036_a 1. MATS connector Use the FLUKE 115 MULTIMETER (P/N 529 035 868) and select . Probe sensor terminals. vmr2008-022-005_a If resistance value is correct, check ECM. Refer to ENGINE CONTROL MODULE (ECM) in this sec- tion. If resistance value is incorrect, repair the connec- tors or replace the wiring harness between ECM connector and the MATS. lmr2006-021-004_a The resistance should be as per following chart. Otherwise, replace the MATS. If resistance value is good, reconnect the MATS and disconnect the ECM connector A on the ECM. Install the ECM ADAPTER TOOL (P/N 529 036 166) to ECM harness.
Probe adapter terminals as follows. MATS Replacement Open seat. Remove rear ventilation box. Refer to AIR INTAKE SILENCER. Disconnect the connector of the MATS. Screw MATS out and install the new one. Torque to 17 N•m (150 lbf• in ).
246 smr2009-030 TEMPERATURE RESISTANCE (OHMS) °C °F NOMINAL LOW HIGH - 30 - 22 12600 11800 13400 - 20 - 4 11400 11000 11800 - 10 14 9500 8000 11,000 0 32 5900 4900 6900 10 50 3800 3100 4500 20 68 2500 2200 2800 30 86 1700 1500 1900 40 104 1200 1080 1320 50 122 840 750 930 60 140 630 510 750 70 158 440 370 510 80 176 325 280 370 90 194 245 210 280 100 212 195 160 210 110 230 145 125 160 120 248 115 100 125 ECM ADAPTER MEASUREMENT PIN RESISTANCE A-J3 A-H3 See table below