Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) COOLANT TEMPERATURE SENSOR (CTS) If resistance tests good, reconnect the CTS con- nector and disconnect the ECM connector A on the ECM. Using a multimeter and the ECM ADAPTER TOOL (P/N 529 036 166) , check the circuit resistance as per table. smr2006-020-057_b TYPICAL 1. Coolant temperature sensor (CTS) NOTE: Overheat signals will appear when coolant temperature reaches: CTS Resistance Test To gain access to the CTS, remove the required parts as described in CTS REPLACEMENT. Disconnect the connector from the CTS and check the resistance of the sensor itself. vmr2008-022-005_a If resistance value is correct, check ECM.

Refer to ECM elsewhere in this section. If resistance value is incorrect, repair the connec- tors or replace the wiring harness between ECM connector and the CTS. The resistance should be as per following chart. Otherwise, replace the CTS. lmr2006-021-005_a CTS Replacement Open seat.

smr2009-030 247 ECM ADAPTER MEASUREMENT PIN RESISTANCE A-A1 A-J2 See table below TEMPERATURE RESISTANCE (OHMS) °C °F NOMINAL LOW HIGH - 30 - 22 12600 11800 13400 - 20 - 4 11400 11000 11800 - 10 14 9500 8000 11,000 0 32 5900 4900 6900 10 50 3800 3100 4500 20 68 2500 2200 2800 30 86 1700 1500 1900 40 104 1200 1080 1320 50 122 840 750 930 60 140 630 510 750 70 158 440 370 510 80 176 325 280 370 90 194 245 210 280 100 212 195 160 210 110 230 145 125 160 120 248 115 100 125 ENGINE TEMPERATURE All 1503 110°C (230°F)