Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) Remove rear ventilation box. Refer to AIR INTAKE SYSTEM. Remove deck extension. Refer to BODY. Disconnect CTS connector and remove CTS. Install the new CTS and torque to 18 N•m (159 lbf• in ). Reinstall remaining removed parts. MANIFOLD ABSOLUTE PRESSURE SENSOR (MAPS) smr2009-030-036_d 1. Disconnect Install the D.E.S.S. key on its post. Briefly press the START button to wake up the ECM. Use the FLUKE 115 MULTIMETER (P/N 529 035 868) and select Vdc. Read voltage as per this table. smr2009-030-036_c TYPICAL 1. Manifold absolute pressure sensor (MAPS) NOTE: This sensor is a dual function device.
When engine is started and it runs at idle speed, the sensor takes the atmospheric pressure and stores it in the ECM. Thereafter, it takes the man- ifold absolute pressure at operating RPMs. Ensure sensor is correctly installed on intake man- ifold. Otherwise, the MAPS could generate a fault code for an unexpected sensor range at idle when it reads the atmospheric pressure. Remove sen- sor and check for oil or dirt on its end and if prob- lem persists, check throttle plate condition/posi- tion and the wiring harness. Perform the follow- ing tests. MAPS Voltage Test To gain access to the MAPS, remove the required parts as described in CTS REPLACEMENT. Disconnect connector from MAPS.
lmr2006-021-006_a If voltage test is good, replace the MAPS. If voltage test is not good, check the continuity of the MAPS circuit. MAPS Resistance Test Disconnect the ECM connector A on the ECM. 248 smr2009-030 CONNECTION VOLTAGE Terminal 1 with battery ground Approx. 5 V Terminal 2 with battery ground Approx. 0 V Terminal 3 with battery ground Approx. 0 V