Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) Using a multimeter and the ECM ADAPTER TOOL (P/N 529 036 166) , check the resistance of circuit A-B4, A-G4 and A-H2. If wiring harness is good, check ECM. Refer to ENGINE CONTROL MODULE (ECM) in this sec- tion. Otherwise, repair the connectors or replace the wiring harness between ECM connector and the MAPS. MAPS Replacement Open seat. Remove rear ventilation box. Refer to AIR INTAKE SYSTEM. Remove deck extension. Refer to BODY. Disconnect MAPS connector and remove the MAPS. Install the new MAPS paying attention to index its tab into the adaptor notch. Apply Loctite 243 (blue) on screw then torque to 10 N•m (89 lbf• in ).
Reinstall remaining removed parts. smr2008-023-018_a The resistance should be as per following chart. Otherwise, replace the EGTS. If resistance tests good, reconnect the EGTS and disconnect the ECM connector A on the ECM. Using a multimeter and the ECM ADAPTER TOOL (P/N 529 036 166) , check the circuit resistance as per following table. EXHAUST GAS TEMPERATURE SENSOR (EGTS) smr2009-030-040_a 1. Muffler 2. Exhaust gas temperature sensor (EGTS) NOTE: Overheat signals will appear when ex- haust temperature reaches: EGTS Resistance Test To gain access to the EGTS, remove the required parts as described in EGTS REPLACEMENT.
Disconnect the connector from the EGTS and check the resistance of the sensor itself. smr2009-030 249 ECM ADAPTER MEASUREMENT PIN RESISTANCE A-J4 A-H4 See table below TEMPERATURE RESISTANCE (OHMS) °C °F NOMINAL LOW HIGH - 30 - 22 12600 11800 13400 - 20 - 4 11400 11000 11800 - 10 14 9500 8000 11,000 0 32 5900 4900 6900 10 50 3800 3100 4500 20 68 2500 2200 2800 30 86 1700 1500 1900 40 104 1200 1080 1320 50 122 840 750 930 60 140 630 510 750 70 158 440 370 510 80 176 325 280 370 90 194 245 210 280 100 212 195 160 210 110 230 145 125 160 120 248 115 100 125 ENGINE TEMPERATURE All 1503 110°C (230°F)