Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) KNOCK SENSOR (KS) vmr2008-022-005_a If resistance value is correct, check ECM. Refer to ENGINE CONTROL MODULE (ECM) in this sec- tion. If resistance value is incorrect, repair the connec- tor or replace the wiring harness between ECM connector and the EGTS. EGTS Replacement Remove the LH rear storage basket. Disconnect the exhaust hose from muffler. Unplug the EGTS connector. Unscrew EGTS from muffler. Apply LOCTITE 518 (P/N 293 800 038) on the middle threads of EGTS. 1. Knock sensor (KS) KS Dynamic Test Using the B.U.D.S. software, monitor the knock sensor using the Faults section.

Start the engine and bring engine RPM above 5000 RPM. If no fault code occurs, the knock sensor is good. Otherwise, do the following. Ensure sensor and cylinder head contact surfaces are clean and mounting bolt and washer are cor- rect and properly torqued down. NOTE: It is necessary to remove intake manifold to inspect contact surfaces. Refer to INTAKE MANIFOLD AND INTERCOOLER section. Check the knock sensor resistance. smr2008-013-041_a 1. Apply Loctite 518 in this area Install the EGTS. Tighten the sensor to 16 N•m (142 lbf• in ). Plug the EGTS connector. Install all other removed parts. KS Resistance Test To gain access to the KS, remove the required parts as described in KS REPLACEMENT.

Disconnect the connector from knock sensor har- ness. 250 smr2009-030