Section 04 FUEL SYSTEM Subsection 02 (ELECTRONIC FUEL INJECTION (EFI)) vmr2008-022-005_a If wiring harness is good, check ECM. Refer to ENGINE CONTROL MODULE (ECM) in this sec- tion. Otherwise, repair the connector or replace the wiring harness between ECM connector and knock sensor. smr2009-030-038_a 1. KS connector Using a multimeter, check the resistance be- tween both terminals on the knock sensor. KS Replacement Open seat. Remove rear ventilation box. Refer to AIR INTAKE SYSTEM. Remove deck extension. Refer to BODY. Remove air intake silencer. Refer to AIR INTAKE SYSTEM. Remove the intake manifold. Refer to INTAKE MANIFOLD AND INTERCOOLER in the ENGINE section.
Disconnect KS sensor connector. Unscrew and remove knock sensor. Clean contact surface, apply Loctite 243 in threaded hole then install the new knock sen- sor. Torque screw to 23 N•m (17 lbf•ft). The resistance should be as per the following chart. If resistance is not good, replace knock sensor. If resistance is good, reconnect the knock sensor connector and disconnect connector A from ECM. Using a multimeter and the ECM ADAPTER TOOL (P/N 529 036 166) , check circuit resistance as per following table. smr2009-030-037_a NOTICE Improper torque might prevent sen- sor to work properly and lead engine to severe damage of internal components. Replug connector. Reinstall remaining removed parts.
smr2009-030 251 ECM ADAPTER MEASUREMENT PIN RESISTANCE @ 20°C (68°F) A-C3 A-G2 5 M