Section 04 FUEL SYSTEM Subsection 03 (FUEL TANK AND FUEL PUMP) GENERAL NOTICE Whenever repairing the fuel system, always check for water infiltration in the fuel tank. Replace any damaged, leaking or deteri- orated fuel line. WARNING Fuel lines remain under pressure at all times. Always proceed with care and use appro- priate safety equipment when working on a pressurized fuel system. Wear safety glasses. SYSTEM DESCRIPTION The fuel system is comprised of: A fuel tank A non-vented fuel tank cap A fuel pump module mounted inside the fuel tank A fuel vent system, and A variety of hoses. The fuel pump module is basically comprised of: 1.
An electric fuel pump mounted inside a canister type pump reservoir 2. A lower inlet filter 3. An upper outlet filter 4. A pressure regulator 5. A float type fuel level sensor. WARNING Always disconnect battery prior to working on the fuel system. Fuel is flammable and explosive under certain conditions. Always work in a well ventilated area. Do not al- low fuel to spill on hot engine parts and/or on electrical connectors. Proceed with care when removing/installing high pressure test equipment or disconnecting fuel line connec- tions. Use B.U.D.S. software to release fuel pressure prior to removing a hose. Cover the fuel line connection with an absorbent shop rag.
Slowly disconnect the fuel hose to minimize spilling. Wipe off any fuel spillage in the bilge. Before reconnecting battery, make sure there is no unusually strong fuel odor present and if so, vent the bilge area thoroughly. WARNING When the repair is completed, ensure that hoses and connections from fuel rail to the fuel pump are properly secured. Then, pres- surize the fuel system. After carrying out a fuel pump pressure test, use the valve on the fuel pressure gauge to release the pressure (if so equipped). WARNING The fuel pump is energized for a few seconds each time the START button is depressed. It builds fuel system pressure very quickly.
Prior to pressing the START button, ensure there are no disconnected or damaged fuel lines that may leak fuel in the vehicle. A high pressure leak test must be carried out whenever a fuel system component has been disconnected. smr2008-022-007_a FUEL PUMP MODULE 1. Fuel pump reservoir 2. Lower inlet filter 3. Upper outlet filter 4. Fuel pressure regulator 5. Float type fuel level sensor Fuel Pump Operation When the pump is in operation, it draws fuel into the canister through a lower inlet filter and a disk type valve. The pressurized fuel is pushed through an upper outlet filter to the fuel rail.
Excess fuel pressure generated by the pump is routed from the upper filter back to the pump can- ister reservoir by a pressure regulator mounted on the pump reservoir cover. WARNING Ensure wires and hoses are routed and se- cured away from any vibrating, rotating, moving or hot components or sharp edges. Use appropriate shields and fastening de- vices as per factory standards. 256 smr2009-031