Section 04 FUEL SYSTEM Subsection 03 (FUEL TANK AND FUEL PUMP) When the START button is pressed, the electrical system is powered. The fuel pump will come on for approximately 2 seconds to pressurize the fuel rail in preparation for the engine start. The ECM supplies the ground signal to turn on the fuel pump motor. The pressure regulator will ensure appropriate fuel pressure is supplied to the injectors. When the ECM receives a signal to shut down the engine (START/STOP switch, safety lanyard, or T.O.P.S. sensor) it removes the fuel pump ground signal. smr2009-031-003_a RH SIDE OF FRONT VENTILATION BOX 1.
Inlet valve Fuel Level Indication An electric float type fuel level sensor is mounted on the side of the fuel pump reservoir. As the float moves with changing fuel levels, it varies a resistance that changes the voltage signal com- ing fromthe information center (multifunction gauge).This signal is representative of the fuel level. The information center interprets the fuel level voltage signal that comes back from the fuel level sensor. It then displays the proper fuel level bars and a low fuel warning message when required. The information center will also trigger the beeper which produces the appropriate beep signal to warn the driver of a low fuel condition.
The fuel level sensor resistance is at its lowest value when the fuel tank is full, and at its highest value when the tank is empty. Refer to the FUEL LEVEL SENSOR in this subsec- tion for fuel level sensor testing procedures. smr2009-031-004_a RH SIDE OF HULL (FRONT PART) 1. Outlet valve The inlet valve is located high in the watercraft to prevent water entry in fuel tank. The inlet valve is a check valve that allows air to enter fuel tank to prevent fuel starvation. It also prevents fuel to flow out of fuel tank. Fuel Tank Vent System Operation smr2009-031-002_b 1. Inlet valve smr2009-031-002_a 1. Fuel tank 2. Fuel tank cap 3. Inlet valve (check valve) 4.
Outlet valve (fuel pressure relief valve) The outlet valve is a pressure relief valve that is normally closed to prevent water entry in fuel tank. It also prevents air to flow out. smr2009-031 257