Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 03 (FUEL TANK AND FUEL PUMP) Test when Cranking or Starting Engine Crank or start engine and observe fuel pressure. The fuel pressure should be the same as above. If pressure is good, fuel pump and pressure regu- lator are functioning correctly. A rapid pressure drop indicates leakage either from the fuel rail or from the fuel pump check valve. Check fuel rail for leaks. If leak occurs while pressing the START button and fuel rail is not leaking, then replace fuel pump module. A slow pressure drop indicates leakage either from a fuel injector or from the fuel pressure regulator in the fuel pump module.

To check fuel injectors for leaks, refer to the ELECTRONIC FUEL INJECTION (EFI) subsection. If injectors are not leaking, then replace fuel pump. Release fuel pressure in system using the valve on the pressure gauge. Remove pressure gauge and reinstall fuel hose on fuel pump module. 529035709 smr2009-031-018_a 1. Connect to fuel pump 2. Connect to outlet hose Test when Engine Is Stopped Remove D.E.S.S. key from its post to prevent en- gine starting. Press the START button and observe fuel pres- sure. Repeat twice. Release pressure in system using the valve on the pressure gauge between each test so that the reading returns to zero (0). WARNING Wipe off any fuel spillage in the bilge.

Fuel is flammable and explosive under certain conditions. Always work in a well ventilated area. Reinstall all removed parts. PROCEDURES FUEL HOSES AND OETIKER CLAMPS Fuel Hose Inspection Inspect all fuel hoses for wear, kinks, cracks or any other types of damages. Inspect all clamps for tightness. Fuel Hose Replacement When replacing fuel lines on all SEA-DOO wa- tercraft models, be sure to use type hose approved by BRP for pressurized hoses, and smr2009-031-019_a FUEL PUMP PRESSURE TEST 1. Valve on gauge smr2009-031 263 MODELS FUEL PRESSURE (when pressing the START button) 1503 4-TEC supercharged intercooled 386 - 414 kPa (56 - 60 PSI)