Section 04 FUEL SYSTEM Subsection 03 (FUEL TANK AND FUEL PUMP) Fuel Level Troubleshooting smr2009-031-024_b INDEXING WITH FUEL TANK 1. Align mark with the writing on hose Use B.U.D.S. to check for a fault code. Refer to MONITORING SYSTEM AND FAULT CODES. Reinstall all other removed parts. Refer to their subsections. When vehicle reassembly is complete, carry out a FUEL TANK LEAK TEST and a FUEL SYSTEM HIGH PRESSURE LEAK TEST as described in this subsection. Fuel Level Sensor Voltage Test First ensure battery is fully charged. Lift suspension using the iS up button to gain ac- cess. NOTE:
If more height is required or if the iS can- not be used, manually lift suspension by the an- chor points close to handlebar and safely lock in this position. Do not lift the watercraft from the anchor points. From under the moving deck steering area, dis- connect the 6-pin connector. FUEL LEVEL SENSOR Fuel Level System Overview A float type fuel level sensor mounted on the fuel pump module sends a signal to the information center. smr2008-022-007_b TYPICAL FUEL PUMP MODULE 1. Fuel level sensor smr2009-042-005_d 1.
6-pin connector The information center interprets this signal and turns on the appropriate number of segments of a bar type fuel level indication in the lower RH side of the digital screen in the information center. Connect the DIAGNOSTIC HARNESS (P/N 529 036 179) to make an in-line connection between the disconnected connector.
smr2009-031 271 FUEL LEVEL TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE Fuel gauge always display EMPTY – Wiring/connectors – Fuel level sensor – Float stuck in low position Fuel gauge always display FULL – Water in fuel pump connector – Float stuck in full position Fuel level sensor fault code – Wiring/connectors – Fuel level sensor Fuel gauge displays wrong level – Low battery voltage – Fuel level sensor fault