Section 04 FUEL SYSTEM Subsection 03 (FUEL TANK AND FUEL PUMP) Place fuel tank retaining strap ends in anchoring clips. Temporarily use tape to hold straps on the top of fuel tank. smr2009-031-017_b 1. Quick connect fitting (high pressure fuel hose) 2. Vent hose 3. Harness connector Disconnect filler hose from fuel tank. NOTE: Removing retaining screws of the filler neck may help to disconnect hose from fuel tank. smr2009-031-027_a 1. Fuel tank retaining strap 2. Clip anchor securing strap to hull Secure a long retaining strap end with a short strap end on top of fuel tank. NOTE:
Fuel tank retaining straps are paired one long and one short together, and two consecutive pairs are installed in opposing directions to stag- ger the metal retainers. See following illustration. smr2009-031-026_a 1. Filler hose 2. Retaining clamp NOTE: Take note of wiring harness, hoses and cable routing for proper reinstallation. Also note method used for securing with locking ties. Detach fuel tank retaining straps. Remove fuel tank from the vehicle. Remove fuel pump as necessary. Refer to FUEL PUMP in this subsection. Inspect hull and flotation foams for wear. smr2008-022-016_a REAR FUEL TANK RETAINING STRAPS ILLUSTRATED 1. Long retaining straps 2.
Short retaining straps Properly secure wire harness, cables and hose as prior to removal using appropriate locking ties. Install fuel tank filler hose as shown. Torque re- taining clamps as per exploded view. Fuel Tank Installation NOTE: Apply torque values as specified in the ex- ploded view. Reinstall fuel pump if it was removed. Refer to FUEL PUMP in this subsection. Ensure flotation foams are properly positioned. Insert fuel tank in hull. 270 smr2009-031