Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 04 FUEL SYSTEM Subsection 03 (FUEL TANK AND FUEL PUMP) Fuel Level Sensor Removal smr2008-022-018_f TYPICAL FUEL PUMP MODULE 1. Fuel pump module connector smr2008-022-029 FUEL LEVEL SENSOR Alternately drain then fill fuel tank and measure the sensor resistance between pins C and D of the fuel pump connector. See table in FUEL LEVEL SENSOR RESISTANCE TEST AT INFORMATION CENTER. Remove fuel pump module from fuel tank, see FUEL PUMP REMOVAL in this subsection. WARNING The upper filter and fuel pump reservoir on the fuel pump module contain fuel which will drain out when fuel pump module is not in an upright position.

Drain all fuel from the upper fuel filter and fuel pump reservoir in an appropriate container. NOTE: Note routing of fuel level sensor wires prior to disconnecting the sensor from the fuel pump module flange. Disconnect the fuel level sensor connector from the fuel pump module upper flange. smr2008-022-018_e TYPICAL FUEL LEVEL SENSOR RESISTANCE TEST If readings are out of specifications, replace sen- sor. When everything else has been tested and fuel level is still not working, try a new information center. smr2008-022-021_a 1. Fuel level sensor connector Disconnect the ground wire from the pressure regulator. Be careful not to bend the ground con- tact on the pressure regulator.

smr2009-031 273