Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 01 MAINTENANCE Subsection 03 (STORAGE PROCEDURE) STORAGE PROCEDURE SERVICE PRODUCTS Description Part Number Page BRP FUEL STABILIZER ................................................................. 413 408 600 ............................................. 7 DOW CORNING 111..................................................................... 413 707 000 ............................................. 9 LOCTITE 767 (ANTISEIZE LUBRICANT) ....................................... 293 800 070 ............................................. 9 XPS LUBE......................................................................................

293 600 016 .........................................7, 9 PROCEDURES WARNING Always stop the engine before refueling. Fuel is inflammable and explosive under certain conditions. Always work in a well ventilated area. Do not smoke or allow open flames or sparks in the vicinity. Fuel tank may be pressurized, slowly turn cap when open- ing. When fueling, keep watercraft level. Do not overfill or top off the fuel tank and leave watercraft in the sun. As temperature increases, fuel expands and might overflow. Always wipe off any fuel spillage from the watercraft. Periodically inspect fuel system.

PROPULSION SYSTEM Jet Pump Cleaning Clean jet pump by spraying water in its inlet and outlet and then apply a coating of XPS LUBE (P/N 293 600 016) or equivalent. WARNING Always remove safety lanyard cap from post to prevent unexpected engine starting before cleaning the jet pump area. Engine must not be running for this operation. Jet Pump Inspection Remove impeller cover and check if jet pump is water contaminated; if so, refer to JET PUMP sub- section for the repair procedure. NOTICE Should any water be trapped inside fuel tank, severe internal damage will occur to the fuel injection system. ENGINE FUEL SYSTEM Engine Oil and Filter Replacement Change engine oil and filter.

Refer to LUBRICA- TION SYSTEM subsection. Fuel System Inspection Verify fuel system. Check fuel hoses for leaks. Replace damaged hoses or clamps if necessary. Intercooler Draining It is important to expel any trapped water that may have accumulated from condensation in the exter- nal intercooler. Fuel System Protection The BRP FUEL STABILIZER (P/N 413 408 600) or equivalent should be added in fuel tank to pre- vent fuel deterioration and fuel system gumming. Follow manufacturer's instructions for proper use. NOTICE Failure to drain the intercooler may cause severe damage to this components.

NOTICE Fuel stabilizer should be added prior to engine lubrication to ensure fuel sys- tem components protection against varnish deposits. Proceed as follows: 1. Loosen the clamp retaining the intercooler out- let hose. 2. Remove the intercooler outlet hose from the in- tercooler. NOTE: This hose feeds the inlet of the throttle body. 3. Drape a couple of shop rags over the iS module to protect it from any expelled water from the intercooler. Fill up fuel tank completely. Ensure there is no wa- ter inside fuel tank. smr2009-014 7