Section 01 MAINTENANCE Subsection 03 (STORAGE PROCEDURE) smo2008-001-053_a TYPICAL 1. Flushing adaptor (P/N 295 500 473) 2. Hose 13 mm (1/2 in) 3. Air hose male adapter NOTICE Failure to drain the exhaust mani- fold may cause severe damage to this compo- nents. smo2009-002-151_a 1. Hose alignment lines 2. Hose clamp 3. Intercooler outlet hose 4. iS module Engine Coolant Replacement Antifreeze should be replaced every 200 hours or every two years to prevent antifreeze deteriora- tion. 4. Start engine and rev up to 4000 RPMs several times. Water will be expelled from intercooler. NOTE: Prevent air intake system from aspirating foreign objects which may cause severe engine or damage. 5.
Stop engine. 6. Install intercooler outlet hose. NOTICE Failure to replace the antifreeze as recommended may allow its degradation that could result in poor engine cooling. If coolant is not replaced, test the coolant density using an antifreeze hydrometer. Replace coolant if necessary. For the coolant re- placement procedure, refer to COOLING SYSTEM subsection. Exhaust System Protection The exhaust system is self draining, but the ex- haust manifold needs to be drained to avoid dam- ages if watercraft is stored in area where freezing weather is present.
Using the flushing connector located at the rear of vehicle, inject pressurized air (at 380 kPa (55 PSI)) into system until there is no more water flowing from jet pump. NOTICE Improper antifreeze density might lead coolant to freeze if vehicle is stored in area where freezing point is reached. This would seriously damage the engine. Engine Internal Lubrication Engine must be lubricated to prevent corrosion on internal parts. Lubrication of the engine is recommended at the end of the season and before any extended stor- age period to provide additional corrosion protec- tion. This will lubricate the engine intake valves, the cylinders and the exhaust valves.
To lubricate the engine, proceed as follows: 1. Open seat and remove the rear ventilation box. 2. Disconnect ignition coil connectors. WARNING When disconnecting coil from spark plug, al- ways disconnect coil from main harness first. Never check for engine ignition spark from an open coil and/or spark plug in the engine compartment as spark may cause fuel vapor to ignite. smr2009-021-004_a 1. Flushing connector The following hose can be fabricated to ease draining procedure. 8 smr2009-014