Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 01 MAINTENANCE Subsection 03 (STORAGE PROCEDURE) NOTICE Never cut the locking ties of ignition coil connectors. This would allow mixing the wires between cylinders. ELECTRICAL SYSTEM Battery Removal For battery removal, cleaning and storage, refer to CHARGING SYSTEM subsection. 3. Clean ignition coil areas to avoid falling dirt into cylinder. 4. Remove ignition coils. 5. Unscrew spark plugs. 6. Using an ignition coil as a puller, remove spark plugs. VEHICLE Bilge Cleaning Clean the bilge with hot water and mild detergent or with bilge cleaner. Rinse thoroughly. Lift front end of watercraft to completely drain bilge.

Body and Hull Cleaning Wash the body with soap and water solution (only use mild detergent). Rinse thoroughly with fresh water. Remove marine organisms from the hull. NOTICE Never clean body parts or hull with strong detergent, degreasing agent, paint thin- ner, acetone, etc. Replace damaged labels/decals. smr2006-016-030_a 1. Ignition coil 2. Spark plug Body Repair If any repair is needed, refer to BODY subsection. 7. Spray XPS LUBE (P/N 293 600 016) into each spark plug hole. 8. Crank the engine a few turns to distribute the oil on cylinder wall. NOTE: To crank engine, use the drowned mode to avoid injecting fuel. Fully depress throttle lever and hold for cranking engine. 9.

Apply LOCTITE 767 (ANTISEIZE LUBRICANT) (P/N 293 800 070) on spark plug threads then reinstall them. 10. Prior to inserting the ignition coil to its loca- tion, apply some DOW CORNING 111 (P/N 413 707 000) around the seal area that touches the spark plug hole. 11. Reinstall ignition coils. 12. Ensure the seal seats properly with the engine top surface. 13. Reconnect ignition coil connectors. 14. Install all other removed parts. Anticorrosion Treatment Wipe off any residual water in the engine compart- ment. Spray XPS LUBE (P/N 293 600 016) over all metallic components in engine compartment. Vehicle Protection Apply a good quality marine wax on body and hull.

The seat should be left partially open during stor- age. This will prevent engine compartment con- densation and possible corrosion. If the watercraft is to be stored outside, cover it with an opaque tarpaulin to prevent sun rays and grime from affecting the plastic components, wa- tercraft finish as well as preventing dust accumu- lation. NOTICE The watercraft should never be left in water for storage, stored in direct sunlight or stored in a plastic bag. smr2009-014 9