Section 05 ELECTRICAL SYSTEM Subsection 02 (POWER DISTRIBUTION) Fuse box Cover Installation When installing a fuse box cover, ensure the seal is properly seated. If the seal has been removed, ensure to reinstall it as illustrated. smr2009-016-011_a FRONT OF ENGINE 1. Engine grounds A cable connected to the engine behind the ex- haust manifold, is connected at the other end to the battery ground post to complete the ground circuit. smr2007-027-003_a TYPICAL 1. Wider lip here Bus-bars A bus-bar is a conductive aluminum bar with two or more terminals that plug into the fuse box contacts in the same way that a fuse does.
It receives current from one terminal and conducts the current to all other terminals into which it is connected. The terminals conduct current through their circuit wires to the electrical com- ponents. smr2009-016-026_b LH SIDE OF ENGINE 1. Battery ground cable 2. Exhaust manifold water inlet fitting CAN Distribution Bus-bars The CAN bus-bars in fuse box 1 connect the LO and HI bars to different CAN enabled com- ponents. This effectively links the components together so they may communicate between each other as required for proper system opera- tion. Refer to CONTROLLER AREA NETWORK (CAN) for more details.
smr2009-027-012 BUS BAR POWER DISTRIBUTION These bus-bars are also used for low power signal circuits (CAN bus), and for ground circuits with a common grounding point. As can be seen in the simplified diagram, the battery directly powers two bus-bars in fuse box 2 (FB2) through terminals A1 and A5, which in turn redistribute power to other components. That power is then available for the components to utilize when they are activated. Terminals A3 to A4 supply 12 Vdc power through a 30 A fuse to the iS module for the iS motor.
Ground Distribution Bus-bar The ground bus-bar collects the grounds from dif- ferent components and connects them to the en- gine grounds through terminal E5 in fuse box 2 (FB2-E5). 284 smr2009-049