Section 05 ELECTRICAL SYSTEM Subsection 02 (POWER DISTRIBUTION) smr2009-027-010_b FUSE BOX 2 BUS BAR IDENTIFICATION 1. 12 Vdc from battery 2. 12 Vdc from battery 3. CAN LO 4. CAN HI 5. Ground bus-bar smr2009-027-011_a FUSE BOX 1 BUS BAR IDENTIFICATION 1. Primary switched power 2. Secondary switched power If the electrical system is energized and the en- gine is not started, the ECM will open the power relay ground circuit to shut off power after ap- proximately 3 minutes, unless the START button is pressed again. When the power relay open, it isolates the bat- tery from the electrical components, including the ECM, therefore preventing excessive battery drain.
The only current drain on the battery when power is switched off by the ECM is for the GPS in the information center. It receives power through pin 1 of the information center (not illustrated). This is used to maintain the GPS memory of the satellite locations for approximately two hours. The power relay in FB2 is connected directly to one of two 12 Vdc bus bars in FB2. When the START/STOP button is pressed, it completes a 12 Vdc circuit to wake up the ECM, which in turn completes the power relay ground circuit. Electrical System Activation 1. Press the START/STOP button to energize the electrical system. 2. Install the safety lanyard (D.E.S.S.
key) on its post to maintain the Information Center active when testing procedures require it. Installing the D.E.S.S. key without pressing the START/STOP button will not turn on electrical power. Pressing the START button without the D.E.S.S. key installed on its post will turn on electrical power without starting the engine; the informa- tion center will cycle through a self-test function and shut off its display after a few seconds. How- ever, the electrical system will stay powered up for approximately three minutes after the START button was depressed. NOTE: If the START/STOP button is pressed and held without the D.E.S.S.
key installed, the infor- mation center will stay on as long as the START button is held without cranking the engine. smr2009-027-010_c 1. Power relay When the power relay closes, it applies 12 Vdc to a bus bar located in fuse box 1 (FB1) through terminal D6, which in turn distributes power to the other 12 Vdc bus-bar and the remainder of the fused circuits. Terminal D4 of FB1 then supplies the main ECM power through a 15 A fuse in FB2. smr2009-049 285