Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 05 ELECTRICAL SYSTEM Subsection 02 (POWER DISTRIBUTION) If B.U.D.S. is being used for communicating with the electronic modules, or if the information cen- ter must be ON for testing, selecting modes of operation, changing key settings, or for other functions accessed through the information cen- ter, the D.E.S.S. key must be installed. NOTE: To prevent the electrical power from shutting down after approximately 3 minutes, press the START button before the three minute power-up period ends. Keep in mind that an electrical component may require more than one fuse, one low amperage rated fuse for its control circuit, and another higher rated fuse for the main component power.

These two fuses may not be in the same fuse box. TROUBLESHOOTING DIAGNOSTIC TIPS NOTE: It is a good practice to check for fault codes using B.U.D.S. software as a first trou- bleshooting step. Refer to COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE subsection. IMPORTANT: When troubleshooting an electrical system fault, check battery condition, cables and connections first. @; 1. Fuse 2. Check if melted 3. Ampere rating A visual inspection of a fuse may not be conclu- sive. Two metal contacts are visible at the top of the fuses. They can be used for testing the fuse us- ing a fuse tester or a multimeter. They can also be used for testing the circuit the fuse protects with- out removing the fuse.

However, when testing a fuse using an ohmme- ter, the fuse should always be removed from the fuse box. Circuit Testing Check the related-circuit fuse condition with a fuse tester or ohmmeter. A visual inspection on its own could lead to an incorrect conclusion. Electrical Connection Inspection When replacing an electric or electronic compo- nent, always check electrical connections. Make sure they are tight, make good contact, and are corrosion-free. Dirty, loose or corroded contacts are poor conductors and are often the source of a system or component malfunction. Pay particular attention to ensure that pins are not bent or pushed out of their connectors.

Ensure all wire terminals are properly crimped on wires, and connector housings are properly fas- tened. Check for signs of moisture, corrosion or dullness. Clean pins properly and coat them with DIELEC- TRIC GREASE (P/N 293 550 004) or other appropri- ate lubricant (except if otherwise specified) when reassembling them. Pay attention to ground wires. WARNING When replacing a fuse, do not use a higher rated fuse than recommended. Use of a higher rated fuse can lead to severe compo- nent or circuit damage, an overheat condi- tion, and possibly and electrical fire. If a fuse has burnt out, the source of the malfunction should be identified and corrected before applying power to the vehicle.

TESTING SEQUENCE Electrical Power Does Not Come ON Electrical system power up is normally identified by the information center powering up and cycling through its self-test function. If the information center does not come on, check the following: Ensure battery is properly connected. Check the BATT. fuse in FB2. Check for activation of the power relay in FB2. Fuse Inspection If an electrical system fault occurs, check the fuses. If a fuse is burnt, replace it with a fuse of the same rating. 286 smr2009-049