Section 05 ELECTRICAL SYSTEM Subsection 02 (POWER DISTRIBUTION) Check the ECM fuse in FB2. Check the GAUGE fuse in FB1. If you cannot feel the power relay activating when pressing the START button, or if you suspect that it does not function correctly, refer to POWER RE- LAY in this subsection. If no voltage is measured, test the wire jumper between FB1-D6 and FB2-A10. Also test for a voltage drop across the power relay main contact between the long bus-bar in FB2-B7 and FB1-D6. If a voltage drop is measured, the relay power contact or wire jumper connections may be bad. Refer to POWER RELAY CONTINU- ITY TEST in this subsection.
PROCEDURES Power Relay Ground Circuit Continuity Test Test continuity of wire between FB2-B10 and ECM connector pin B-H2. This wire provides the ground to the power relay from the ECM. If the relay, relay power and ground circuits test good, refer to STARTING SYSTEM. The START switch circuit may not be powering the ECM. If the START switch and its circuit test good, then refer to ELECTRONIC FUEL INJECTION as the ECM may not be providing the ground for the relay to close. POWER RELAY The power relay is a plug-in type that may be in- verted by 180° at installation and still function cor- rectly. If the power relay operation is suspected, try a known good relay before carrying out other tests.
If the replacement relay does not function, refer to POWER RELAY INPUT VOLTAGE TEST. If you do not have a replacement relay, refer to POWER RELAY CONTINUITY TEST. Power Relay Input Voltage Test 1. Remove the power relay from the fuse box. 2. Set multimeter to Vdc. 3. Probe fuse box as per following table. Power Relay Continuity Test To test the power relay, carry out the following. 1. Remove the relay from the fuse box. 2. Use the FLUKE 115 MULTIMETER (P/N 529 035 868) , and select the position. 3. Probe relay as per following table. If battery voltage is not read at A12, check the fol- lowing items in FB2: Fuse 17 (30 A BATT.). Wiring/connectors from battery to pin FB2-A1.
12 Vdc Bus bar connecting B1 through B8 for proper contact. Wire jumper A2 to B2 (behind fuse box). Wire jumper B8 to A12 (behind fuse box). If battery voltage is read at A12 and B12, refer to POWER RELAY GROUND CIRCUIT CONTINUITY. If voltage is read at contact A12 but not at B12, check fuse box jumper between B12 and B7. smr2007-027-050_a 4. Connect a 12 Vdc battery as in following illus- tration and probe relay again. Power Relay Output Voltage Test The power relay output voltage is applied to the short bus-bar in FB1. To check for relay output voltage, slightly lift the short bus-bar in FB1 and test for battery voltage at a bus-bar contact.
smr2009-049 287 RELAY INPUT VOLTAGE TEST FUSE BOX PIN VOLTAGE A12 to battery ground (coil) Battery voltage B12 to battery ground (main contact) Battery voltage TERMINAL RESISTANCE 30 87 Open circuit (OL)