Section 05 ELECTRICAL SYSTEM Subsection 04 (CHARGING SYSTEM) CHARGING SYSTEM SERVICE TOOLS Description Part Number Page ENGINE LEAK TEST KIT................................................................ 295 500 352 ......................................... 302 SERVICE TOOLS OTHER SUPPLIER Description Part Number Page ELECTRO SPECIALTIES BATTERY LOAD TESTER....................... 710 ......................................... 306 EXTECH INDUCTIVE AMMETER .................................................. 380941 ......................................... 298 GENERAL Voltage Regulator/Rectifier The rectifier receives AC current from the mag- neto and transforms it into direct current (DC).
The voltage regulator, included in the same unit, limits voltage to a maximum level to prevent any damage to electrical components. NOTICE When performing a test with the en- gine running above approximately 4500 RPM for 3 seconds, be aware that suspension will move up to its predefined position then, it will stop in that position. Wait until suspension is stopped before working on the watercraft. Keep away from moving parts. SYSTEM DESCRIPTION The purpose of the charging system is to maintain the battery at a full state of charge and to provide the electrical system with the required electrical power for normal vehicle operation.
Magneto The magneto is the primary source of electrical energy. It transforms a magnetic field into an elec- tric current (AC). The magneto has a 3 phase, delta wound, 18 pole stator that is rated at 380 watts. smr2008-025-001_a 1. Voltage regulator/rectifier unit Battery The battery supplies DC power to the electric starter for cranking the engine. During engine starting, it also supplies DC power to every elec- trical and electronic system in the vehicle as well as all accessories. At low engine RPM operation and high current load conditions, it supplements the magneto output and helps to maintain a steady system voltage. TYPICAL ! smr2009-033 297