Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 05 ELECTRICAL SYSTEM Subsection 04 (CHARGING SYSTEM) INSPECTION CHARGING SYSTEM OUTPUT First ensure that battery is in good condition prior to performing the following tests. NOTE: It is good practice to check for fault codes using the B.U.D.S. software as a first troubleshooting step. Refer to MONITORING SYSTEM/FAULT CODES section. Output Voltage Test Using B.U.D.S. Connect to the latest applicable B.U.D.S. soft- ware. Refer to COMMUNICATION TOOLS AND B.U.D.S. SOFTWARE section. In B.U.D.S., select the Monitoring tab then the ECM tab. Start engine. NOTE: Connect a garden hose to cool exhaust system. Refer to EXHAUST SYSTEM subsection.

Bring engine RPM as specified in the following ta- ble and read voltage in B.U.D.S. smr2009-033-002_a CHARGING SYSTEM VOLTAGE TEST AT BATTERY POSTS Start engine. NOTE: Connect a garden hose to cool exhaust system. Refer to EXHAUST SYSTEM subsection. Bring engine RPM as specified in the following ta- ble and read voltage with the multimeter. If voltage is above specification, replace voltage regulator/rectifier. If voltage is below specification, check stator output and wiring harness prior to concluding that voltage regulator/rectifier is defective. Refer to PTO HOUSING AND MAGNETO subsection.

Output Current Test with an Inductive Ammeter Use an inductive ammeter such as the EXTECH IN- DUCTIVE AMMETER (P/N 380941) or equivalent. Turn on the ammeter and select 40 Adc. NOTE: Zero set the ammeter before use or read- ing may be erroneous. Detach fuse box #2 from its support. Move fuse box aside to gain access to charging system wire. smr2009-033-001_a 1. Monitoring tab 2. ECM tab 3. Battery voltage If voltage is above specification, replace voltage regulator/rectifier. If voltage is below specification, check stator output and wiring harness prior to concluding that voltage regulator/rectifier is defective. Refer to PTO HOUSING AND MAGNETO subsection.

Output Voltage Test Using a Multimeter Set multimeter to Vdc. Connect multimeter to battery posts. 298 smr2009-033 OUTPUT VOLTAGE TEST USING A MULTIMETER TEST ENGINE SPEED VOLTAGE (DC) 5500 RPM 14.5 ± .5 Vdc OUTPUT VOLTAGE TEST USING B.U.D.S. TEST ENGINE SPEED VOLTAGE (DC) 5500 RPM 14.5 ± .5 Vdc