Section 05 ELECTRICAL SYSTEM Subsection 04 (CHARGING SYSTEM) NOTE: Initial current reading will be higher than specified due to the battery drain from the engine start. This is an indication that the charging sys- tem is operating normally. Current load will come down as the battery recovers its charge. If current reading is far below specification, test stator output and wiring harness prior to conclud- ing that voltage regulator/rectifier is faulty. NOTE: If battery is in poor condition or is not at a full state of charge, current reading will be above specification. Refer to BATTERY in this section for battery testing. smr2009-034-002_c 1.
Fuse box #2 Locate the RED/BLUE wire on terminal A9 of fuse box and clamp the ammeter over it. Output Current Test with a Multimeter NOTICE Charging current may rise over mul- timeter current reading capacity (usually 10 A) possibly causing testing equipment damage. It is preferable to use an inductive ammeter to test the charging system current. Remove charging system fuse. Set multimeter to Adc. Connect probes to fuse holder terminals. smr2009-033-003_a 1. Terminal A9 smr2009-033-005_a Start engine. NOTE: Connect a garden hose to cool exhaust system. Refer to EXHAUST SYSTEM subsection. Bring engine RPM as specified in the following ta- ble and read current with the multimeter.
smr2009-033-004_a 1. Inductive ammeter Start engine. NOTE: Connect a garden hose to cool exhaust system. Refer to EXHAUST SYSTEM subsection. Bring engine RPM as specified in the following ta- ble and read current with the ammeter. smr2009-033 299 TEST ENGINE SPEED CURRENT 5500 RPM Approx. 10 A (while suspension does not move)